Final Step – Installing Vinyl Plank Floor

Installing a new vinyl plank floor can give any room a whole new look and feel in just a few hours. To get the job done right, you need to take the final step: installation.

The installation process for vinyl plank flooring is relatively straightforward, but there are a few key steps that you need to follow to ensure that your new floor looks great and lasts for years to come.

Step 1: Prepare the Subfloor

The first step to installing a vinyl plank floor is to ensure that the subfloor is level and free of dirt and debris. If there are any bumps or irregularities in the subfloor, these must be addressed before you can begin the installation.

To prepare the subfloor, use a level to check for any high or low spots. If there are any, use a self-leveling compound to even out the surface. Once the subfloor is level, use a vacuum or broom to remove any dirt or debris from the surface.

Step 2: Measure and Cut the Planks

Once the subfloor is prepared, you can begin measuring and cutting your vinyl planks to fit the space. Measure the area where you will be installing the planks and then use a saw to cut the planks to size.

It is important to measure twice and cut once – if you make a mistake when cutting, you may end up with planks that are too small or too large for the space.

Step 3: Install the Underlayment

Before you can lay down the planks, you need to install an underlayment. Underlayment helps to protect the subfloor from moisture and provides a cushion for the vinyl planks. It is important to use the correct type of underlayment for your floor – consult the manufacturer’s instructions for the best advice.

When you install the underlayment, make sure that it is flat and level. Use a roller to press it firmly against the subfloor and be sure to overlap the seams when you install multiple pieces of underlayment.

Step 4: Install the Planks

Once the underlayment is in place, you can begin installing the vinyl planks. Start in one corner of the room and work your way across the floor. Use a tapping block and a rubber mallet to tap the planks into place.

Make sure to leave a gap between the planks and the walls to allow for expansion. If you are installing planks in different rooms, be sure to stagger the joints to create a more aesthetically pleasing look.

Step 5: Clean Up

Once you have installed all of the planks, give the floor a good cleaning with a damp mop. This will help to remove any dirt or dust that may have been left behind during the installation process.

Step 6: Enjoy Your New Floor!

After you have completed the installation process, it is time to sit back and enjoy your new vinyl plank floor! With proper maintenance and care, your new floor should last for years to come.